We recently received a new shipment of a softer, more stretchy 1-3/4" and 2-1/14" conductive tubing that has a variety of uses.  Use it by itself, with a V2000 receiver or one of our sections of thick acrylic tube. 

This material is easier to place on your V2000 receiver than the thicker, heavier 1-3/4" we sell due to its elasticity.  We discovered that the thick 1-3/4" diameter was too thick and did not have the stretch to go over a 2" OD tube easily.

   Shown is a piece of the new 2.25" tubing stretched over the end of a 2.5" diameter V2000 receiver.

The 1-3/4" diameter tube will easily stretch over a 2" OD receiver as shown below.

Additionally, the new 2.25" diameter will stretch over a 2.75" OD cylinder easily. 

Don't have a V2000 machine?  You can still experience the wonderful sensation of estim in an open style tube with our new Electro-Tunnel device.  :)    Of course you will have to provide a "helping hand" in using this device, or just position it where you want it and just let the current flow!  Since this is a single-pole electrode, you will need another electrode placed around the balls or even a prostate plug in order to complete the electrical current. 

  Our ComboClip is used to connect the liner to one of your lead wires.  These clips are made to fit a banana pin, but by slipping a small piece of conductive 4x2mm conductive tubing into the socket will allow for a TENS pin to fit nice and snug.

   This picture shows a 6" long acrylic cylinder with a 2" OD diameter tube.  The tubing is a 1-3/4" diameter piece of conductive tube stretched over the ends.  A small piece of large rubber tube is placed over each end to prevent the threat of cutting into the soft conductive liner.  The edges around the cylinder ends are ground and buffed to take any sharp edges off the acrylic tube. 

The basic price of $42.00 includes a 6" long thick walled 2.75" OD acrylic cylinder with a piece of 2.25" conductive tube approximately 8 to 9 inches long and a ComboClip for connecting it to your power box.

If you want a smaller or even longer section made, the price is adjusted accordingly based on the length you want. Use the Drop-Down boxes below to tailor the diameter and length of your customized Electro-Tunnel.  

NOTE: Due to the pricing between the 2" and 2.75" sizes, if you want the 2.0" OD model, you will need to go to that specific product page.